👤
Reginaarnadogarciago
Answered

cite the five steps of checking physical connection of the computer​

Sagot :

Glydelmancerasgo

FIVE STEPS

1.Connect your router. The router is the gateway between the Internet and your home network

2.Access the router's interface and lock it down

3.Configure security and IP addressing

4.Set up sharing and control

5.set up user account

#CARRYONLEARNING

#BRAILIESTPLEASE

XxNiveGuyxXgo

Answer:

Check the physical connections.

  • Check that the Link light — the little red or green light next to the RJ-45 port — is lit on every computer. You must check this light both on the computer itself and on the switch or router the computer is plugged into. If this light is not on, you have a connection problem — most likely a bad cable.

Verify that you can log on.

  • When you’re sure the physical connections are good, you should attempt to log on to each of your network computers using a valid domain user account.

Check the network configuration.

  • Click the Start button, type cmd and press Enter. Then, enter the command ipconfig /all and press Enter.

This command will spit out numerous lines of information. The line you’re looking for should resemble this:

|| IPv4 Address. . . . . . . . . . . : | |

|| 192.168.1.125(Preferred) ||

  • If this part of the output does not show a valid IP address, you need to check that your IP configuration is set correctly and that your DHCP server is working.

Verify that the computers can ping each other.

  • Another basic test you should perform is to use the ping command from a command prompt to make sure that the computers on your network can contact one another.

Explanation:

I Hope It Help❤

Go Training: Other Questions