DIRECTION: TRUE or FALSE. Write T if the statement is TRUE and F if not. Write your answer on the blank provided before the number,
1. Do not wash the tip of the soldering iron with water to speed up its cooling process after use it might corrode the soldering tip.
2. Clean the soldering tip with plastic after used.
3. Hold the mini drill firmly at 180 degrees with the material to be bored.
4. Electronic instruments like oscilloscopes, signal generators, digital multimeters and like should be connected to the power line at least once a week to warm up the circuit.
5. Avoid direct contact of the soldering iron's tip to the tip of the desoldering tool when doing desoldering work.
6. Use only low standard tools and instruments in performing any electronic job.
7. Always use the right tool for the right job.
8. Attempt to use tools or instruments you are not familiar with.
9. Keep hand tools clean and free from ferrous or other contaminants.
10. Be sure to tighten the two nuts holding the tip before using it to have maximum heat transfer to its tip
please pa answer naman po ito brainlest ko po maka sagot
